Tabla de contenido
Publicidad
AMPROBE
12.
CONNECTING THE INSTRUMENT TO A PC
In order to connect the instrument to a PC you must connect the Optical serial cable code
C2001 shipped with the instrument to a PC COM port.
The available transmission speeds are the following:
The value of the transmission speed (Baud Rate) is displayed on the initial screen
(immediately after turning on the instrument, see paragraph 4.2). The value of this
parameter can be modified only with the management software.
For download instructions please refer to software help file.
In order to transfer the memorized data from the instrument to the PC the following
procedure must be followed (after Sw installation):
1. Switch ON the instrument and wait that Initial screen disappears (the rotary
Switch position isn't relevant).
2. Connect the Optical serial output of the instrument to the serial output of the PC
through the Original C2001 serial cable
3. Run the program
4. Select the "Download" command
5. Refer to software help ON Line for further instructions.
9600, 19200, 57600 (default value)
MULTITEST2000
Publicidad
Capítulos
Tabla de contenido
