Tabla de contenido
Publicidad
AMPROBE
3. PREPARATION FOR USE
3.1.
INITIAL CONTROL
This instrument has been checked mechanically and electrically prior to shipment.
Care has been taken to ensure that the instrument reaches you under safe conditions.
You are recommended, however, to carry out a rapid check to detect any possible
damage, which might have been caused during transport. Should this be the case,
immediately contact Amprobe.
Also, check that the packaging contains all the parts listed under paragraph 14.5. In case
of discrepancies contact the dealer.
In case you have to send the instrument back please follow the instructions reported in
paragraph 15.
3.2.
POWER SUPPLY
The instrument can be powered by:
6 batteries 1.5V AA series located in the compartment on the back of the instrument
(not included in the package). For battery life see paragraph 14.3.1.
An external power supply adapter (optional code A0050) to be used only for
ANALYSIS and AUX functions. We recommend that you use only A0050 HT Power
Supply adapter.
For your own safety you're not able to use the external power supply adapter during
Safety Test (LOWΩ, MΩ,
button the Instrument will show the message "ν REMOVE POWER".
The symbol
shows the battery charge: If it is completely "black" the batteries are
fully charged, while the
low to execute the test the instrument will show a warning message. In this case interrupt
,EARTH rotary Switch positions). If you press the START
symbol indicates weak batteries. When the batteries are too
MULTITEST2000
Publicidad
Capítulos
Tabla de contenido
