Meter" Mode - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE

8.6.2. "METER" mode

In this mode the instrument shows the below screens according to the settings made as
per paragraph 8.1.
The symbols used are described in Tab. 3.
For eventual messages displayed see appendix 1 – MESSAGES DISPLAYED.
Following keys are enabled:
F2:
F3/F4:
SAVE:
ENTER/HOLD: to enable/disable the HOLD function (updating interruption) of the
27.09.00
SINGLE PHASE
V1 =
I1 =
P1 =
Q1 =
S1 =
pf1 =
dpf1 =
WAVE
Example of screen
to pass to "WAVE" mode (see paragraph 8.6.3).
to pass to previous/next function respectively.
to save in the instrument memory a record of "Smp" type (see
paragraph 9.2) and the instantaneous values of voltage and current
present on the instrument inputs. This function is disabled during a
recording.
displayed data. All the previous functions remain however available.
When the HOLD function is enabled, the word
When this function is enabled it's not possible to record or take an
17:35:12
POWER
230.0 V
145.3 A
32.91 kW
5.767 kVAR
33.41 kVA
0.99 i
0.99 i
PG- PG+
MULTITEST2000
HOLD is displayed.