Rotary Switch During A Recording; Stopping A Recording Or An Energy Measurement - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE

10.2.2. Rotary Switch during a recording

If You move the rotary switch during a recording the following screen will appear:
This page means that a recording is running but the actual rotary switch position doesn't
correspond to this.
The instrument will continue to record.
10.3.

STOPPING A RECORDING OR AN ENERGY MEASUREMENT

The instrument uses a protective routine to avoid the risk of being disturbed or interrupted
during a recording or an energy measurement. Once a recording or a direct energy
measurement (see paragraph 8.7.2) has been started (with the option PASSWORD
enabled), after about 3 minutes from the last key pressure or switch rotation it won't be
sufficient to press START/STOP (if a recording is running) or F2 (if an energy measuring is
running) to stop the recording, it will be necessary to insert the password.
In order to insert the password (which is not changeable), press the multifunction keys in
the following sequence (within 10 seconds):
Recording
Recording
MULTITEST2000