Basic Setting: Recorder Config - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE
8.2.

BASIC SETTING: RECORDER CONFIG

Place the rotary switch in the ANALYZER position, press the MENU key, using the F1/F2
keys select the RECORDER CONFIG item and press the ENTER Key.
This option allows you to check and eventually modify the recording parameters and the
selected parameters (up to a maximum of 62+Frequency). If the number of selected
values exceeds 63 the message
CONFIG mode is divided into 4 separate sub-pages:
st
1 page: This page allows you to set the START/ STOP mode (AUTO or MANUAL),
the START and STOP time if AUTO mode is selected, the Integration
Period value, the Enabling/Disabling of Voltage Anomalies detection, the
Enabling/Disabling of Harmonics detection. Press ENTER to confirm the
settings and pass to the following page.
Press ESC to leave the Menu without modifying the existing parameters.
nd
2 page: This page is devoted to the settings relevant to the VOLTAGE recording.
Press ENTER to confirm the settings and pass to the following page.
Press ESC to leave this page without modifying the existing parameters.
From this page you can enter the sub-page "Harmonics" which permits to
select the voltage harmonics to be recorded.
Press ENTER to confirm the settings and leave the "Menu Harmonics".
Press ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
rd
3 page: This page is devoted to the settings relevant to the CURRENT recording.
Press ENTER to confirm the settings and pass to the following page.
Press ESC to leave this page without modifying the existing parameters.
From this page you can enter the sub-page "Harmonics" which permits to
select the current harmonics to be recorded.
Press ENTER to confirm the settings and leave the "Menu Harmonics".
Press ESC to leave the "Menu Harmonics" without modifying the existing
parameters.
"too many param" will be displayed. The RECORDER
MULTITEST2000