During Use - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE
Please keep to the usual safety standards aimed at:
♦ Protecting against dangerous currents;
♦ Protecting the instrument against incorrect operations.
Only the accessories supplied with the instrument guarantee compliance with the
safety standards. Accordingly, they must be in good conditions and, if necessary, they
must be replaced with identical models.
Do not take measurements on circuits exceeding the specified current and voltage
limits.
Before connecting cables, alligator clips and clamps to the circuit under test, make sure
that the right function has been selected.
Do not take any measurements under environmental conditions beyond the limits
specified in paragraph 14.4.
Check that batteries are not weak and are installed correctly.
Before connecting test leads to the circuit under test, check that rotary switch position
is correct.
1.3.

DURING USE

Please read the following recommendations carefully and instructions:
ν
WARNING:
Before selecting any function disconnect the test leads from the circuit under test.
When the instrument is connected to the circuit under test do not touch any unused
terminal.
Avoid taking resistance measurements in the presence of external voltages; even
though the instrument is protected, a high voltage may cause malfunctions.
When measuring current, other currents located near the leads may affect the
measuring accuracy.
Non-compliance with the Warnings and/or Instructions may
damage the apparatus and/or its components or injure the
operator.
MULTITEST2000