Setting The Height; Setting A Station With A Control Line (Height Option "On") - Hilti POS 15 Manual De Instrucciones

10.3 Setting the height

If heights are also to be used in addition to setting the station and orientation, i.e. target heights are to be determined
or laid out, the height of the center of the telescope must also be defined.
Two different methods can be used to set the height:
1. If the height of the point on the floor or ground is known, the height of the tool is then measured. The height of
en
the center of the telescope is the sum of these two values.
2. Alternatively, an angle and distance measurement can be made to a point or mark with a known height and thus
by "measuring" in this way, the height of the center of the telescope determined and transferred back to the tool.

10.3.1 Setting a station with a control line (height option "on")

If the "With heights" option has been selected, the station heights will be shown in the "Set station" screen.
These can be confirmed or redefined.
Defining a new station height
Station height can be defined in two different ways:
1. Direct manual entry of the station height.
2. The station height is defined by manually entering the height of a height mark and by measuring the vertical angle
and distance.
1st Direct manual entry of the station height
After the option for redefinition of the station height has been selected from the previous screen, the new station height
can be entered manually here.
2nd Definition of the station height by entering a height and measuring the vertical angle and distance
The station height is transferred "back" to the station from the height mark, so to speak, by entering the reference
height, tool height and reflector height in conjunction with a vertical angle and distance measurement.
When doing this it is essential that the correct tool height and reflector height are entered.
46
Return to previous view.
Enter station height manually or
measure to a height mark.
Confirm station height. Continue
with setting station.
Cancel and return to previous
screen.
Confirm station height. Continue
with setting station.