Environmental Protection; Inspection And Contents Checklist - Mettler Toledo IND570 Manual De Instalación

1.3.

Environmental Protection

When an approved version IND570xx is installed in an area classified as Division 2 or Zone 2/22,
special AC wiring requirements must be met. Refer to document 30205321, IND570xx Division 2,
Zone 2/22 Installation Guide.
1.4.

Inspection and Contents Checklist

Verify the contents and inspect the package immediately upon delivery. If the shipping container is
damaged, check for internal damage and file a freight claim with the carrier if necessary. If the
container is not damaged, remove the IND570 terminal from its protective package, noting how it
was packed, and inspect each component for damage.
If shipping the terminal is required, it is best to use the original shipping container. The IND570
terminal must be packed correctly to ensure its safe transportation.
The package should include:
•
•
•
•
1-8 METTLER TOLEDO IND570 Terminal Installation Manual
VERSIONS OF THE IND570 TERMINAL THAT ARE NOT FACTORY-LABELED AS DIVISION 2 OR
ZONE 2/22 MUST NOT BE INSTALLED INTO A DIVISION 2 OR ZONE 2/22 ENVIRONMENT.
THE IND570xx TERMINAL IS NOT INTRINSICALLY SAFE LEVEL "a" OR "b"! DO NOT USE WITHIN
AREAS CLASSIFIED AS HAZARDOUS DIVISION 1 OR ZONE 0/1/20/21 BECAUSE OF
COMBUSTIBLE OR EXPLOSIVE ATMOSPHERES. FAILURE TO COMPLY WITH THIS WARNING
COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
IND570 terminal
Safety warnings in multiple
languages
Fixed angle mounting brackets
(harsh models only)
Bag of ATEX certified glands for IND570xx harsh versions with ATEX/IECEx approval
WARNING
WARNING
•
Bag of parts for installation. Depending on terminal,
may include ferrites, grommets, rubber feet, sealing
gasket, etc.
•
European Certificate of Conformance (Europe only)
30205319 | 11| 07/2019