Pcb Switch Settings - Mettler Toledo IND570 Manual De Instalación

2.4.6.10.2. Installation in the Panel-mount Enclosure
Available Ports
Both of the RJ45 ports on the PROFINET option can be used when the option is installed into a
panel-mount model. With both ports available, ring and linear PROFINET topographies can be
supported by this installation.
PROFINET Connector for Panel-mount Installation
The installed interface can be connected to the network using a standard 180
connector or a standard network patch cable.
2.5.

PCB Switch Settings

PCB switch settings are described in this section, including settings for main PCB switches and the
discrete I/O (relay) switch.
2.5.1. Main PCB Switches
Four switches (indicated in Figure 2-120, which shows the Analog version of the terminal) are
located on the main PCB. These switches function as shown in Table 2-11.
30205319 | 11 | 07/2019
SW1
Figure 2-120: Main PCB Switches
METTLER TOLEDO IND570 Terminal Installation Manual
PROFINET
SW2
2-67