Options - Mettler Toledo IND570 Manual De Instalación

POWERCELL cells (maximum of 6 POWERCELL cells in IND570xx) from its internal power supply.
An external power supply to power additional cells is not supported. If more than 14 cells are
needed, the IND780 PDX terminal must be used.
When used as part of a PDX cell network, the IND570 provides several diagnostic features such as
automated alerts and cell performance monitoring. These features help lower maintenance costs
and minimize downtime.
1.8.1.4.2. Isolated Serial Ports
The IND570 is designed for use in environments where the connecting cables may be exposed to
lightning surges. To help protect the terminal from damage, the COM1 and COM4 serial port on the
main board of the POWERCELL versions of IND570 and IND570xx are both electrically isolated.
This eliminates the difference in ground levels that can damage the interface circuitry.
1.8.1.5. PowerDeck Scale Platform
The POWERCELL-based PowerDeck platform provides an enhanced set of configuration and
operational capabilities:
•
•
•
1.9.

Options

The following hardware and software options are available for the IND570:
•
•
•
•
•
•
•
•
•
30205319 | 11 | 07/2019
Save and Restore of original platform system parameters stored in each load cell of a
PowerDeck platform during initial factory configuration
Visual Installation Guidance to assist technicians in leveling the platform during installation to
achieve original factory specified performance
Off-center Load Assistance to guide operators during platform use
Discrete I/O
- Internal, high-level and low-level discrete I/O
- Remote discrete I/O via ARM100 module
COM2/COM3 Serial Ports
Ethernet TCP/IP Port
Programmable Logic Control (PLC) interfaces, including:
Analog Output ControlNet™
Modbus TCP
PROFIBUS
COM-570 application software
Drive-570 application software
DYN-570 application software
Fill-570 application software
TaskExpert™ custom application development software
DeviceNet™
 
DP PROFINET
METTLER TOLEDO IND570 Terminal Installation Manual
EtherNet/IP™
1-17