BH FITNESS H8565 Manual De Usario página 8

ELECTRONIC MONITOR
To give you greater control over your
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
If at any time during exercise you
press the START/STOP button then
all of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
Important. Discarded
must be deposited
containers, Figure 1.
FITTING THE ELECTRONIC
MONITOR
FITTING THE HAND-GRIP CABLE
(Pulse sensors)
Take cable (25) coming out of the
handlebar stem and connect it to
cable (35) coming out of the monitor,
Figure 2.
FITTING THE MAIN CABLE
Connect the
coming out of the monitor, Figure 2, to
the terminal block (9) coming out of
the handlebar stem and place the
monitor in the chain cover
MONITOR SCREEN
BRIGHTNESS LEVEL
ADJUSTMENT
1- Switch the monitor on in STOP
mode.
2-Press the "ENTER" and "UP" keys
simultaneously. After about 2 seconds
the monitor will beep.
of speed,
components
in special
terminal block
English
3- Use the "UP" and "DOWN" keys to
increase or decrease the brightness
level.
4- Press any key to save the
brightness setting and return to STOP
mode.
MONITOR FUNCTIONS
This monitor has six keys: ENTER,
TEST, DOWN, UP, START/ STOP,
MODE. The program level you have
selected is shown simultaneously in
the central section of the display. The
six windows at the bottom of the
display show the TIME; RPM/ SPEED;
DISTANCE/ODOMETER
distance covered); CALORIES/WATT;
THR (TARGET HEART RATE); AGE;
PULSE RATE.
This monitor also has 1 manual
program, 6 pre-set exertion level
programs; 1 BODY FAT program; 4
Heart Rate Control programs; 4 user
defined programs.
With the monitor either stopped or
working you can alternate between the
(RPM / SPEED) and (DIST / ODO)
window by pressing the MODE key.
(12)
You can reset of all the values back to
zero by holding the START/STOP key
down for 3 seconds.
MANUAL FUNCTION
Press the START/STOP key to switch
the monitor on, the words PROGRAM
1 will appear on the screen. Use the
UP/DOWN
decrease the exertion level, there are
16 exertion levels.
Programming a time limit: Press the
START/STOP
monitor on, then press the ENTER key
until the time window starts to flash,
8
keys to increase
key to switch
(total
or
the