Spot Marking Preparation And Execution (Spot) - Cebora PLASMA PROF 180 HQC Manual De Instrucciones

Fig. 4.13
N.B. When the system is switched on, the last working setting (i.e. Material-Gas-Thickness-Current) is stored. If the
gas type is changed at the next adjustment and the RUN key is pressed again, the RUN key changes firstly to yellow
during automatic purging, i.e. emptying of the pipes, and then when the system is ready, the RUN key changes from
yellow to green.
4.2.4

Spot marking preparation and execution (SPOT)

Spot marking is a particular type of mark where the trace takes the form of a spot instead of a line or any design typical
of normal marking (see MARK working mode below). The spot marking function can be enabled or disabled directly
by the CNC/Robot, by means of the relevant signal, maintaining the same cutting parameters and consumables. The
spot marking parameters (see Fig. 4.14) are adjusted by means of:
- Current buttons "+" and "-", entering a value within the range [10 ÷ 39] A;
- Spot Time buttons "+" and "-", entering a value within the range [0.01 ÷ 1.00] s;
Fig. 4.14
NOTE: regarding the SPOT execution time, the START command from the CNC/Robot Controller takes priority over
the set Spot Time value.
115/128