Analogue Signals From Power Source To Pantograph Control - Cebora PLASMA PROF 180 HQC Manual De Instrucciones

POWER SOURCE READY
CNC CONNEC-
TOR TERMI-
SIGNAL
NALS
NAME
ON POWER
SOURCE
25 Power
Source
26
Ready
The "Power Source Ready" signal is active high (closed contact).
The "Power Source Ready" signal remains active as long as the power source is ready to cut. As soon as an error status
arises in the power source or the "Robot Ready" signal is deactivated by the Pantograph Control, the "Power Source
Ready" signal is no longer active. This means that the "Power Source Ready" signal can detect power source errors
and pantograph errors.
PROCESS ACTIVE
CNC CONNEC-
TOR TERMI-
SIGNAL
NALS
NAME
ON POWER
SOURCE
27
Process
Active
28
The "Process Active" signal is active high (closed contact).
When the pantograph control initialises the digital "Start" signal, the cutting process begins with the preflow gas, follo-
wed by the cutting operation and then the postflow gas.
From the beginning of preflow gas to the end of post-flow gas, the power source initialises the "Process Active" signal.
The power source is performing the process.
3.2.5

Analogue signals from power source to pantograph control.

WIRING OF AN INSULATED VOLTAGE ANALOGUE OUTPUT.
output voltage 0 ÷ 10 Vdc;
output current 20 mA;
output frequency
V_Arc-ISO
CNC
CONNECTOR
SIGNAL
TERMINALS
NAME
ON POWER
SOURCE
11
V_Arc-ISO
(0÷5V) (0÷10V)
7
POSITION
SIGNAL ON INTERFA-
TYPE
BOARD
Terminal C J3, pin 5
Contact NO J3, pin 6
POSITION
SIGNAL ON INTERFA-
TYPE
BOARD
Terminal C J3, pin 3
Contact NO J3, pin 4
5 Hz max.
POSITION
SIGNAL
TYPE INTERFACE
BOARD
analog out+ J5, pin 3
analog out- J5, pin 4
CE
CE
ON
97/128