Connection To The Cnc Pantograph - Cebora PLASMA PROF 180 HQC Manual De Instrucciones

3.2.1

Connection to the CNC pantograph

The 37-pin CNC connector present on the back of the power source (see fig. 3.4) is supplied together with the
corresponding male floating connector (AMP P/N 182926-1, Fig. 3.5), complete with pins; the customer is responsible
for the remaining connection to the pantograph.
An accessory device is available. This extended analogue interface kit (see fig.5.1 of the Appendix) is designed to
manage additional non-standard signals.
If the generator is equipped with a digital interface, refer to the specific documentation.
Item no 968/969
Connector AMP
P/N 182926-1
Fig. 3.5
93/128