Fitting The Mounting Column - Bosch TCE 4460 Manual Original

3. Remove the plastic guards of the extending horizontal
arm and the rear guard of the locking lever.
Fig. 8: Removing the guards
4. Loop the hoisting strap around the mounting column.
5. Fit the hoisting strap on the hoisting crane and raise
the mounting column.
Robert Bosch GmbH
Commissioning | TCE 4460 | 45
Fig. 9: Raising the tilting mounting column
4.2.3

Fitting the mounting column

1. Remove the outer snap ring (A) using suitable pliers
and remove the pin (B).
Fig. 10: Removing the pin
2. Align the holes on the cylinder shaft and the shock
absorber rod.
en
|
1 695 105 428 2013-11-04