Installing The Machine - Bosch TCE 4460 Manual Original

en 50 | TCE 4460 | Commissioning
i
The tire pressure can be read on the pressure gage,
which is securely attached to the mounting column.
i
Pressure gage conforms to EEC Directive 87/217.
i
The button (D) next to the pressure gage releases
the air from the tires when pressed.
Fig. 28: Button on pressure gage
4.2.7

Installing the machine

1. Connect the ground cable (Fig. 5).
2. Re-attach the side cover.
3. Loosen the screws with which the TCE 4460 is at-
tached to the pallet.
Fig. 29: Installing the machine
Damage warning!
The straps could damage the supply hoses
of the cylinder or add-on components of the
TCE 4460.
€
Take care when fitting the straps.
|
1 695 105 428 2013-11-04
4. Fit suitable straps (strap (A): 1 m, strap (B): 3 m)
with sufficient load-bearing capacity as shown in the
figure.
Fig. 30: Strap end stops
Warning: Risk of tipping!
The center of gravity of the TCE 4460 is not
in the middle.
€
Always raise the device slowly.
5. Raise the TCE 4460 using a hoisting crane and install
in the designated area. In doing so, observe the safe
distances specified in the figure.
Fig. 31: Installation distances
Robert Bosch GmbH