Fitting The Pressure Gage - Bosch TCE 4460 Manual Original

10. Insert spring(s) (I) and adjusting sleeve (L) on the
shaft (G) of the unseating cylinder.
Fig. 23: Inserting the spring(s) and adjusting sleeve
11. Fit the adjusting sleeve (L) on the shaft (G) while
fully inserting the pin (M) so as to ensure that it
does not poke out from the outline of the sleeve
(L).
12. Screw in the dowel pin (N) for fitting the pin (M).
Fig. 24: Fitting the adjusting sleeve
13. Position the bead breaker blade (O) on the arm (E)
and secure with the pin (P).
Fig. 25: Fitting the bead breaker blade
Robert Bosch GmbH
Commissioning | TCE 4460 | 49
4.2.6

Fitting the pressure gage

1. Attach the pressure gage (A) to the mounting column
using the screws provided (B).
Fig. 26: Fitting the pressure gage
2. Remove the hoses (A) and (B) of the pedal for the
tire inflater (C) from the lower housing section and
connect to the quick-release connections as shown
in the figure.
Fig. 27: Connecting the hoses
en
|
1 695 105 428 2013-11-04