Guard For Bead Breaker Blade; Guards For Mounting Head And Fitting Tool; Setting The Guide Rails - Bosch TCE 4460 Manual Original

en 56 | TCE 4460 | Operation
5.1.2

Guard for bead breaker blade

Fig. 45: Attaching guard for bead breaker blade
5.1.3 Guards for mounting head and fitting tool
Fig. 46: Attaching guards for mounting head
!
Always check the wear status of all plastic parts
before working with the machine, and replace these
if necessary.
|
1 695 105 428 2013-11-04
5.2

Setting the guide rails

In order to work with tires up to 30", it is possible to
set position 4 of the guide rails, as shown in Fig. 3.
1. Pull the rim-width gage (A) outwards.
2. Slide the moving part of the guide rail into the desi-
red position.
3. Release the rim-width gage (A) and check that it is
correctly locked in place in the corresponding hole
for the desired position (the guide rail must not be
able to move).
Fig. 47: Setting the guide rails
Robert Bosch GmbH