Compressed Air Connection - Bosch TCE 4460 Manual Original

en 52 | TCE 4460 | Commissioning
4.3

Compressed air connection

1. Connect the TCE 4460 to the compressed air supply.
i
With a bayonet connection it is sufficient to move
the compressed air hose to the connection of the
filter unit and tighten the threaded clip.
Fig. 36: Compressed air connection
2. Set a pressure of between 8 bar and 10 bar.
« First pull the pressure reducer (red knurled
screw) upwards and then turn to set the pressure
to between 8 bar and 10 bar.
« Check the pressure on the pressure gage
!
A quick-release coupling with 1/4 thread is supplied
with the vehicle to enable a compressed air con-
nection to be made even if no bayonet connector is
available.
3. Use a 14 mm wrench to remove the swivel connec-
tion at the filter unit.
Fig. 37: Removing the swivel connection
|
1 695 105 428 2013-11-04
4. Pull out the swivel connection and attach the quick-
release connection. Finally, tighten with a 14 mm
wrench.
!
Fit the original seal back in position.
Fig. 38: Fitting quick-release connection
!
For setting the lubricating oil flow, see Section 6.2.6.
5. Connect the compressed air hoses from the filter
unit as shown in Fig. 39 and Fig. 40.
i
The VGP output supplies the pedal for the tire infla-
ter.
Fig. 39: Filter unit connection/VGP/pedal for tire inflater
Robert Bosch GmbH