Nogueira EXPRESS-5040 Manual De Instrucciones página 56

ADJUSTING THE POSITION OF HANDLES
After the settings of needles and handles displayed on the previous page, down
the needles, turning manually the steering wheel. With fully downloaded ne-
edles, the measure M must be equal to 5 mm (fig.96). In case of divergence,
proceed as follows:
IMPORTANT!
There are several factors that interfere when you tie a knot, and, in some cases,
might require a different adjustment from the indicated above.
The 5mm measure indicated above is only a reference for the initial regulation.
If after regulating you observe that the knotter is not tying (is not knotting), it
is recommended that you perform some practical tests, as follows:
Stop the machine and change the measure M. Restart the operation and observe
the first bales. If necessary, repeat the test by altering again the measure M until
you obtain the ideal regulation, one that allows a quality knot.
To regulate the measure M, proceed as follows:
1- Loosen the two nuts F and turn the spindle R until the measure above.
2- Tighten the nuts.
NOTE: It might occur that the ideal measure M is not the same in the two pick-ups.
F
M
R
HANDLES
F
fig.96
IMPORTANT!
The regulation must be performed with the needles completely lowered.
Regulate the two pick-ups.
56
Instructions Manual