Height Of The Collector - Nogueira EXPRESS-5040 Manual De Instrucciones

HEIGHT OF THE COLLECTOR

The Baler leaves the factory with the collector adjusted to the transport position.
Before starting the baling it must be placed in the work position.
On land suitable for baling, the distance between the tips of the collecting springs
and the soil must be approximately 3 cm (see fig.24).
PUTTING THE PICK-UP IN WORKING POSITIONFirstly, connect the piston
hydraulic hose A to one of the valves from the remote control of the tractor.
1 – Activate the valve from the remote control and lift the pick-up completely.
2 – Remove the bolt B.
3- Activate again the valve from the remote control and lower the pick-up until
the springs are about 3cm from the ground.
ATTENTION!
In order to prevent damages to the springs, certify that they do not touch the
ground. If necessary, activate the hydraulic piston and lift the pick-up a little.
A
26
fig. 25
Instructions Manual
springs
B
fig. 24
fig. 26