Adjustment Of The Retaining Clamp - Nogueira EXPRESS-5040 Manual De Instrucciones

ADJUSTMENT OF THE RETAINING CLAMP

When tying the bale the cord is caught between the retaining clamp and disk.
During this process, the retaining clamp is pressed by two springs against the
disk, fastening the cord. The pressure that these springs exert on the disk is
very important. If it is low (insufficient), the cord will slip. If it is too much, the
cord will be stuck and the knot will be damaged.
It is advisable to start the tying with a gap of 3 mm at the end of the springs
(measure M of fig.148). Adjust the pressure by means of the nut P.
NOTE: It is advisable to protect the contact surfaces between the springs with
a fine layer of grease, and so avoid them locking.
68
SPRINGS
RETAINING
DISC
Instructions Manual
RETAINING
CLAMP
fig.147
P
fig.148