Wheels; Rammer; Calcador - Nogueira EXPRESS-5040 Manual De Instrucciones

WHEELS

Verify the pressure of the tires.
After between the first 4 and 8 hours of work, retighten all the nuts of the wheels.
Frequently verify the tightening during the first 100 hours of work.
35 lbs/pol (2,4 Kg/cm
2

RAMMER

CALCADOR

The function of the rammer is to maintain the material collected pressed against
the collecting springs, aiming at feeding the machine uniformly and constantly.
However, it is important to not that the rammer must compress the material
collected without restricting its flow inside the machine.
The rammer leaves the factory regulated for a typical work condition.
If it is making the feeding difficult or, on the other hand, it is not helping to
maintain the material flow, it will be necessary to regulate it. In this case loosen
the nut of stop A and reposition it.
The higher that stop A is positioned, the greater the pressure of the rammer on
the product and vice versa.
32
)
2
fig. 47
Instructions Manual
fig.45
40 lbs/pol (2,8 Kg/cm
2
B
RAMMER
)
2
fig. 46