Knotter Trigger Regulation - Nogueira EXPRESS-5040 Manual De Instrucciones

KNOTTER TRIGGER REGULATION

The trigger leaves the factory properly regulated, and it does not need any ad-
justments. There should be a slack of 4 to 5mm between the trigger and the
roller. In case it is not adjusted, proceed as follows:
1 – Manually turn the machine handwheel and place the lever A from the knotter
in a vertical position (picture 104).
2 – Check if there is a slack of 4-5mm between the roller and the teeth from the
trigger, as shown in the picture 105.
3 - In case it is necessary to adjust the slack, loosen the bolts from the two
supports B and move the star wheel until you the slack as indicated above.
4 – Retighten the fixing bolts from the two supports B.
KNOTTER
TRIGGER
KNOTTER
TRIGGER
4 to 5 mm
60
fig. 103
ROLLER
fig. 105
Instructions Manual
A
fig. 104
B
fig. 106