Correcting The Format Of The Bale - Nogueira EXPRESS-5040 Manual De Instrucciones

CORRECTING THE FORMAT OF THE BALE

The good formed bale depends on the uniformity in feeding the machine. Defor-
med bales are produced when the pressing chamber is fed unevenly (a greater
quantity of material on one side or the other).
If the position of pin A is changed, the penetration of the fork inside the pressing
channel is altered, allowing the amount of material to be increased or decreased
on one side or other of the bale.
This adjustment is simple and can be done without needing to use any tool.
fig. 120
fig. 122
Holes below increase
the volume on this
side of the bale.
NOTE:
The ideal adjustment depends on different factors, such as: type and conditions
of the products, ridges etc. In order to determine it, some trial and error may
be required, until finding the one which will bring the best result.
fig. 121
Instructions Manual
A
Holes above incre-
ase the volume on
this side of the bale.
fig. 123
61