Wbe 4120 Dt; Control Keys - Bosch WBE 4120 Instructions De Réparation

en 44 | WBE 4120 / WBE 4120 D / WBE 4120 DT | How to use the machine and surfi ng menu
2.1.4 Auto-diagnosis
Press "SET" until the notice "TST" is shown and then
"MM/INCH".
Left Display Right Display Description
Msr
ex.: 384
Ex.: 603
ex.: 179 Ex.: 580
Ex.: 2
Left Display Right Display Description
Enc
Left Display Right Display Description
SP
Left Display Right Display Description
A0 510
A1 510
A2 510
A3 510
A4 ###
A5 200
A6 ###
A7 200
Left Display Right Display Description
INP ON/OFF
Left Display Right Display Description
Cnt
1 500
6
Left Display Right Display Description
Led
Left Display Right Display Description
Tar
Left Display Right Display Description
Rel off
|
1 695 600 579 2016-08-02
Press "+" DISTANCE to roll down
menu
1° shown value:
measured tension left pick-up
2° shown value: measured tension
right pick-up
3° shown value: phase angle dif-
ference
4° value: Ratio between the round-
ed off pick-ups
It shows the position of the
encoder from 0 to 255
Speed in turn/min of the shaft
Reading analog entry of the right
pick-up
Press "+" DISTANCE to roll down
the menu
Reading analog entry of the left
pick-up
Reading analog entry of the en-
larged right pick-up
Reading analog entry of the en-
larged left pick-up
NON USED
Reading distance potentiometer
NON USED
Reading diameter potentiometer
Position of the carter: OFF open,
ON lowered
Press "+" DISTANCE to roll down
the menu
Overall launches ex:1500
Daily launches, since when the bal-
ancing machine has been turned
on
Press "+" DISTANCE to roll down
the menu
Press "+" DISTANCE to roll down
the menu
Start of the respective balancing
procedure
2.2

WBE 4120 DT

i
The initialization of the software is displayed approx.
20 seconds after switching on the WBE 4120 DT The
start page is displayed after a further 40 seconds.
i
If the image does not appear correctly, carry out
self-calibration of the monitor (making reference to
the monitor user manual).
The following menus can be selected on the start page
Sim- Denomina- Qui si accede al menù
bolo zione
Wheel Balan- Balancing program
cing
Settings and Personal settings, calibration and cus-
service tomer service.
2.2.1

Control keys

The WBE 4120 DT is operated by way of the < I > key
and the arrow keys. The corresponding functions are
described in Table 1.
Tasto Descrizione
Arrow keys Navigation in the menus and alteration of the
rim data values
o r u z
<I> Confirmation of settings.
Starts measurement.
Ends measurement.
Tab. 1: Funzioni dei tasti comando
Bosch Automotive Service Solutions GmbH