Creating Vacuum In External Channelled Bags; Oil Change Alarm And Work Cycles Display - Berkel BV 400/25 Manual De Uso Y Mantenimento

Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 - BV 600/60 Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 – BV 400/25H – BV 600/60
Rev. 01 - 04/2019 - Cod. 1500656 - Instruction manual for vacuum chamber packaging machines Mod. C46-C46H-C62
6.2 CReaTINg vaCUUM IN eXTeRNal ChaNNelleD BagS
1) Switch the machine on and set the sealing value by selecting the SEal function using SEl
seconds; deactivate the GAS functions if present (it is advisable to program a special cycle).
2) Press the button PuMP
cycle by lowering lid
3) When vacuum formation inside the bag is complete, i.e. the vacuum gauge indicates -1.0 bar, press SEl
Bag sealing follows and the cycle is completed with re-entry of air and opening of the lid.
warNINg!
ThIS OPeRaTION IS ONly POSSIBle WITh ChaNNelleD BagS.
BUSTa
goffraTa
•
•

6.3 oIl CHaNgE alarM aNd work CyClES dISPlay

When the device reaches the limit of 25000 cycles, immediately after it is switched on and at the
end of each working cycle, the words "all" and "oIl" appear on the display alternately. This
indicates that it is time to change the pump oil. The machine will continue to function but it is of
the utmost importance to change the oil as soon as possible following the indications given under
the heading "CHANGING THE PUMP OIL".
EXECuTEd CyClES dISPlay
The number of executed cycles can be called up on the display at any time by pressing the PuMP
8
and +/-
keys simultaneously: the word "cyc" and a 3-digit number will appear alternately. The number
4
which appears on the display must be multiplied by 100. (e.g.: the figure 048 indicates that 48×100= 4800
work cycles have been executed).
ZEroINg THE EXECuTEd CyClES dISPlay
Once an oil change has been carried out, the previous number of executed cycles must be zeroed by pressing
7
the PuMP , SToP
26
display, press the SToP
; position the bag at about 20 mm beyond the sealing bar
7
B
.
•
a
4 5
4 5
PROG
8
and +/- keys simultaneously. when the number of cycles appears on the
4
8
key to send the figure back to zero.
6
6
PUMP
SEL STOP
at 2.7 - 3
6
, then start up the
a
6 .
B
7
7
8
8
7
, SToP