20
20
A B B I N D U S T R I A L D R I V E S D C S 8 8 0 Q U I C K G U I D E - 3 A D W 0 0 0 5 4 5 R 0 2 0 0
A B B I N D U S T R I A L D R I V E S D C S 8 8 0 Q U I C K G U I D E
—
DCS880 control panel
Refer to ACS-AP-x assistant control panels user's manual (3AUA0000085685) for detailed information.
Direction of speed
Actual control location
Local reference up
Soft key 1
Status LED:
• Green for normal operation
• Flashing green for alarms
• Red for faults
Loc/Rem – Changes between local and
remote control of the drive.
Stop – Stops the drive in local control
from DCS Control Panel and when
the Start-up Assistant is used.
DCS880 Set up control panel assistant
DCS880 commissioning is supported by assistants available in the control panel.
The digital inputs can be tested by 10.04 DI force data.
The analog inputs can be tested by 12.11 AI1 actual value and AI1 scaled value 12.12 (AI2 = 12.21 and 12.22).
Start commisioning always with date and time setting, follow the assistants and close with parameter
backup in the control panel.
General display features
Following modes are available in the MAIN MENU:
1. Basic assistant (menue / assistant)
a. Data and time
2. DCS880 assistant (menue / assistant)
a. Name plate data
b. Autotuning field current controller
c. Autotuning armature current controller
d. First motor turning
e. Speed feedback assistant
(Tacho fine tuning not available)
f. Autotuning speed controller
g. Field weakening assistant (only used when
maximum speed is higher than base speed)
h Make a back up
3. Parameter backup (menue / parameter backup)
Local reference - change by arrow
buttons (up/down)
Signals selected by edit Home View
(option menue)
Soft key 2
Help – Displays context sensitive
information when the button is pressed.
Local reference down
Start – Starts the drive in local control
from DCS Control Panel and when the
Start-up assistant is used.
USB connection to composer PC Tool
Parameters entered by assistant
99.07 M1 used field exciter type
99.10 Nominal mains voltage
99.11 M1 nominal current
99.12 M1 nominal voltage
99.13 M1 nominal field current
99.14 M1 nominal (base) speed
30.11 M1 minimum speed
30.12 M1 maximum speed
30.19 Minimum torque 1
30.20 Maximum torque 1
30.35 M1 current limit bridge 1
30.34 M1 current limit bridge 2
31.30 M1 overspeed trip margin
31.44 Armature overcurrent level
94.23 OnBoard encoder pulses/revolution
94.24 OnBoard encoder type
94.25 OnBoard encoder speed calculation mode
94.07 M1 tacho type
94.08 M1 tacho voltage at 1000 rmp
90.41 M1 feedback selection
23.12 Acceleration time 1
23.13 Deceleration time 1
31.58 M1 field current low level
28.17 M1 EMF/field control mode
BE_PAN_002_DCS880_overview_a.ai