Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento página 35

The drive name is also presented in a small bar above the time remaining. The bar turns blue to
indicate the camera is set to record to this USB-C flash disk. To record to a different drive, press
and hold the name of the drive you wish to record to. While recording, the bar is red.
Tap the storage indicator on the LCD touchscreen to access the storage manager
This menu displays the amount of free space on each USB-C flash disk used by your camera, as
well as the name of the drive, length of the last clip, total number of clips, and the file format for
each drive.
You can format your media from this menu. For more information, see the 'preparing media for
recording' section of this manual.
TIP Tapping the drive name in the storage menu sets it as the active drive. Your
Blackmagic Studio Camera fills this drive first.
Triggering Record using ATEM Mini
When recording ISO files from an ATEM Mini Pro or Extreme model switcher, you can also
trigger record on all studio cameras connected via HDMI.
For example, the 'record stream' palette in ATEM Software Control has a checkbox labeled
'record in all cameras'. When this checkbox is enabled and you click or press record, all
connected studio cameras will start recording as well. This means you only have to click or
press one button to start recording on all cameras simultaneously.
Refer to the ATEM Mini manual for more information.
Touchscreen Controls 35