Using Blackmagic Zoom Demand - Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento

Using Blackmagic Zoom Demand

The controls on the Zoom Demand are mappable through the Camera settings. To change the
button functions, refer to the 'setup settings' chapter in the 'settings' section.
The following commands are set as default:
1 Zoom F1
This is the zoom function button 1. By default, it is mapped as a 'record' button
for recording to an external drive connected to an available USB-C port on your
Blackmagic Studio Camera.
2 Zoom F2
This is the zoom function button 2. On the other side of the controller is an identical
button that performs the same function, allowing for left and right handed control.
By default, it is set as a quick zoom function which instantaneously punches into the
live image.
NOTE The quick zoom feature is only visible on the Blackmagic Studio
Camera's LCD and will not be visible on the output video connected to
a switcher or recorder.
3 Zoom F3
This is the zoom function button 3. On Blackmagic Studio Camera 4K Pro, the default
action for this button is set to program return. This would normally be a switcher's
program return feed, but can be any SDI signal connected to your camera's SDI input.
On Blackmagic Studio Camera 4K Plus, the default action is set to auto white balance.
4 Zoom F4
This is the zoom function button 4. On Blackmagic Studio Camera 4K Pro, the default
action for this button is set to push to talk. When connected to an ATEM switcher via
SDI, press and hold the button to communicate with the switcher operator.
On Blackmagic Studio Camera 4K Plus, the default action for this button is set to
frame guides.
1
4 3 2
Blackmagic Zoom and Focus Demands
IN OUT
76