Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento página 44

Dynamic Range
Adjust the 'dynamic range' setting by tapping the dynamic range icons. Blackmagic Studio
Cameras have three dynamic range settings:
Video The 'video' setting is perfect for live to air broadcast and lets you work faster by
recording to a high contrast look suitable for direct delivery or minimal post processing.
Video uses Rec.709 primaries and has 6 stops over middle gray with another 3 stops in
specular highlights. This is a good option if you want an accurate starting point that still
has a pleasing gamma curve.
Extended The 'extended video' setting is based on Blackmagic Wide Gamut with contrast and
Video saturation applied. The most notable differences to the video mode come from the
magenta/green axis having less saturation which is more typical of print film, and even
more highlight roll off than video mode which causes highlights to desaturate more.
It has a slightly flatter gamma curve that results in less saturation.
Film The 'film' setting shoots video using a log curve that allows you to maintain the greatest
dynamic range and maximizes the information in your video signal to help you get the
most out of color grading software, such as DaVinci Resolve.
NOTE When recording Blackmagic RAW using 'film' dynamic range, the image will
appear dull and desaturated on your touchscreen. This is because the image file
contains a lot of data that hasn't yet been graded to suit a standard display. However
you can monitor the video on the LCD, HDMI and SDI output using a display LUT, or
look up table, designed to simulate a standard contrast. For more information, refer to
the '3D LUTs' section in this manual.
Project Frame Rate
Project frame rate provides a selection of frame rates commonly used in the film and television
industry. For example, 23.98 frames per second. This frame rate is normally set to match your
playback speed and audio sync used in your post production workflow and delivery requirements.
Eight project frame rates are available, including 23.98, 24, 25, 29.97, 30, 50, 59.94 and 60
frames per second.
NOTE When you coordinate a multi camera recording through ATEM Mini, Blackmagic
Studio Cameras will change their frame rate to match the frame rate setting of the
ATEM Mini. If you are working with an SDI based ATEM switcher, you will need to set
your project frame rate on your camera to match the switcher.
Off Speed Recording
By default, the project and sensor frame rates are matched for a natural playback speed.
Tapping the 'off speed recording' switch icon lets you set your sensor frame rate independently.
Menu Settings 44