Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento página 85

Lum Mix Setting
The color corrector built into Blackmagic cameras is based on the DaVinci Resolve
primary color corrector. DaVinci has been building color correctors since the early
1980's and most Hollywood films are color graded on DaVinci Resolve than any
other method.
This means that your color corrector built into the camera has some unique and
creatively powerful features. The YRGB processing is one of those features.
When color grading, you can choose to use RGB processing, or YRGB processing.
High end colorists use YRGB processing because you have more precise control over
color and you can independently adjust the channels with better separation and more
creative options.
When the Lum Mix control is set to the right side, you have the 100% output of the
YRGB color corrector. When you have the Lum Mix control set to the left side, you get
100% output of the RGB corrector. You can set the Lum Mix to any position between the
left and right to get a blend of output from both the RGB and YRGB correctors.
Drag the sliders left or right to adjust Contrast, Saturation, Hue and
Lum Mix settings
Which is the correct setting to use? That's up to you, as color correction is a pure
creative process and there is no right and wrong. The best setting is what you like the
most and what you think looks good!
Synchronizing Settings
When connected, camera control signals are sent from your ATEM switcher to the
Blackmagic camera. If a setting is accidentally adjusted from your camera, camera
control will automatically reset that setting to maintain synchronization.
Using ATEM Software Control 85