Using The Sun Hood - Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento

The 3D LUT can then be easily toggled 'on' or 'off' but will always travel with the Blackmagic
RAW file as it is written into the clip itself. DaVinci Resolve also has an 'Apply LUT' switch in the
RAW settings palette for enabling or disabling the 3D LUT in the Blackmagic RAW file.
The 'Apply LUT' setting in DaVinci Resolve is the same setting as in the camera. This means that
when shooting you can direct the colorist to use the LUT by setting it in the camera, but they
can switch it off easily in DaVinci Resolve by setting 'Apply LUT' to 'off'.

Using the Sun Hood

The sun hood helps you to see the screen in bright or sunny conditions. To attach the sun hood,
place its top edge along the top ridge of the Blackmagic Studio Cameras LCD and hinge it
down until it clicks into place.
Place the top edge of the sun hood into the slots above the LCD and lower the hood into
position. A latch underneath the LCD will secure the hood to the camera. When removing the
sun hood, press the latch to release the hood and then lift the hood away from the camera.
Once attached, open the top shade completely, allowing for the side flags to spring open then
let the top rest on the flags.
When the top shade is opened, the side flags will also open
Using the Sun Hood 71