Blackmagic Design Studio Camera 4K Plus Manual De Instalación Y Funcionamiento página 48

Clean Feed
Tap the 'clean feed' switch in the 'LCD', 'HDMI' or 'SDI' menus to disable all status text and
overlays for that output. The record tally will still be displayed on the LCD when clean feed
is applied.
It is a good idea to apply clean feed to outputs you are feeding to your switcher or any external
recorders when using a multicam setup.
Your studio camera will display a record tally even in clean feed mode
NOTE LUTs will still be applied to outputs with 'clean feed' enabled. To disable LUTs,
disable the 'Display 3D LUT' switch in the 'monitor' menu.
Display 3D LUT
Your Blackmagic Studio Camera can apply 3D LUTs to any output to approximate the look of
color graded footage. This is especially useful when recording clips using 'film' dynamic range.
If your camera has a 3D LUT active, use this setting to independently apply that LUT to your
LCD touchscreen, HDMI or SDI output.
Tap the 'Display 3D LUT' switch in the 'LCD', 'HDMI' or 'SDI' pages to enable 3D LUTs for those
outputs. For details on loading and using 3D LUTs, see the 'LUTs' information in the 'menu
settings' section of this manual.
Zebra
Tap the 'zebra' switch in the 'LCD', 'HDMI' or 'SDI' menus to enable zebra guides for those
outputs. For more information on setting zebra levels, see the 'touchscreen controls' section in
this manual.
Focus Assist
Tap the 'focus assist' switch in the 'LCD', 'HDMI' or 'SDI' menus to enable focus assist for
those outputs. For more information on focus assist and setting focus assist levels, see the
'touchscreen controls' section in this manual.
Frame Guide
Tap the 'frame guide' switch in the 'LCD', 'HDMI' or 'SDI' menus to enable frame guides for
those outputs. For more information on frame guides and choosing different guides, see the
'touchscreen controls' section in this manual.
Menu Settings 48