Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.5
Attaching EMC lines
i
Installation of the EMC kit is described in the
attached mounting instructions 1 689 978 492.
5.6
Installing voltage stabilizer
(special accessories)
i
Mounting and operation of the voltage stabi-
lizer is described in the operating instructions
1 689 979 951.
5.7
Installing COM� interface into PC
i
Only for PC units without a COM4 port.
i
Installation of the COM4 interface is described in the
installation instructions 1 689 978 441.
5.�
Connecting voltage supply line
1. When using KMA 822: Remove trolley rear panel.
2. Remove protective cap on rear of voltage stabilizer.
i
The connecting cables 1 684 463 503 and
1 684 463 504 are included in the scope of delivery
of the trigger electronics 1 687 023 357.
3. Pull connecting lines through openings of protective
cap.
4. Join connecting cables for supply voltage using hexa-
gon bolts, washers and hexagon nuts.
5. Mount protective cap.
2
Fig. 16:
Connecting to voltage stabilizer
1 Connecting cable 1 684 463 504
2 Connecting cable 1 684 463 503
Robert Bosch GmbH
Preparatory work for EPS �15 | CRI�CRI� ���� | 27
1
i
If the voltage stabilizer is to be used frequently, e.g.
for tester set VPM 844 oblong holes must be filed
into the protective cap. Connection of doubled-up
lines to a single output is performed as shown in the
following illustration.
Fig. 17:
Connecting for frequent use
5.9
Connecting RS2�2 connecting line
i
The RS232 connecting cables are included in
the scope of delivery of the trigger electronics
1 687 023 357.
1. When using KMA 802: Remove rear panel of PC pro-
tective casing.
2. Join RS232 connecting line (1 684 462 298) to
COM4 port (X61) of KMA 800 PC unit.
5.10
Routing lines
!
Generally the following applies: All connecting lines
must be routed such that they will not cause people to
trip up so that they will not be caught by moving parts.
CRI�CRI� ���� | 27
| 27
en
|
1 689 978 562
2012-03-29
Publicidad
Capítulos
Tabla de contenido
