AL-KO Solo R13-72.5 HD Manual De Instrucciones página 50

en
Lubricating points
All joint components, plus rotating and bea-
ring points
Axles of front and rear wheels
ADVICE
The front and rear wheels must be remo-
ved for greasing the axles and bearings
(see section "Wheel change").
Starter battery
This is a sealed FAAM L12-17 battery with 12 V
rated voltage and control valves. The battery is
completely maintenance-free, i.e. the battery fluid
level requires neither to be checked nor topped
up.
No charger is supplied for the starter battery of the
ride-on mower.
Precise battery designation: see battery box. The
starter battery is located under the access flap at
the front of the ride-on mower (10/5).
The starter battery is always supplied from the
factory pre-charged.
WARNING!
Danger if the starter battery is not
handled correctly!
Please comply with the following points
to avoid dangers from incorrect handling
of the battery!
Do not store the starter battery in the imme-
diate vicinity of naked flames, do not burn it
or place it on heaters. Risk of explosion.
Keep the starter battery in a cool, dry room
(10 - 15 °C) over winter. Avoid storing at tem-
peratures below the freezing point.
Do not leave the starter battery without
charge for a long period. If the starter battery
is not used for a long period, it should be char-
ged using a suitable charger.
Do not smash the starter battery. The electro-
lyte (sulphuric acid) causes chemical burns
to the skin and clothing - immediately rinse
away with plenty of water.
Keep the starter battery clean. Only wipe
clean with a dry cloth. Do not use water, pe-
trol, thinners or the like for this purpose!
Keep the connection terminals clean and
grease them with terminal grease.
Do not short-circuit the connection terminals.
50
Charging the starter battery
Charging is required:
Before putting into storage before the winter
break.
If the machine will not be used for a long time
(longer than 3 months).
WARNING!
Danger if the starter battery is not
charged correctly!
The charging current of the charger must
not exceed 5 A, and the charging voltage
can be max. 14.4 V. Risk of explosion of
the starter battery if the charging current
is more powerful!
Always remove the ignition key before
starting work on the battery.
We recommend charging this maintenance-free,
gas-tight starter battery using a specially suitable
charger (which can be obtained through retail out-
lets).
Comply with the operating instructions of the char-
ger manufacturer before and during charging of
the starter battery.
1. Remove the ignition key (07/3).
2. Open the access flap (10/1).
CAUTION!
Danger of short circuit!
To avoid a short circuit, always dis-
connect the negative cable (-) of the
battery first, and reconnect it last!
Always remove the ignition key be-
fore starting work on the battery!
3. Connect the charger terminals to the connec-
tion terminals of the battery.
ADVICE
Check the polarity:
Red terminal = positive terminal
(+)
Black terminal = negative termi-
nal (-)
4. Connect the charger to the mains and switch
it on.
Maintenance