Requesting Settings In The Service Menu - Grundfos Conex DIA-G Instrucciones De Instalación Y Funcionamiento

11.10 Requesting settings in the service menu

Main menu > Service
Submenu 1
Sensor 1
Sensor 2
Test current
Test relay
Test display
In the "Service" menu, the most recent messages
(list of events), the measuring data for the sensors,
the data for the auto test and the sensor data can be
displayed for the relevant sensor.
In addition, the current outputs, relays and the
display can be tested, i.e. the proper operation of the
®
Conex DIA-G and connected warning and safety
equipment can be checked.
Sensor 1/2
In the "Sensor 1" or "Sensor 2" submenu, the
following menu points are available:
• List of events
• Measured value
• Auto test
• Sensor data
• Settings.
Submenu 2
List of events
Measured value
Aut. test
Sensor data
Settings (S1)
List of events
Measured value
Aut. test
Sensor data
Settings (S2)
Current output 1
Current output 2
Relay 1: off
Relay 2: off
Relay 3: off
Relay 4: off
Alarm: off
List of events: The last 10 events (limit value
exceeded or sensor fault) are stored chronologically
with date and time and can be viewed. The events
are shown in the display as follows:
List of events
Number: 1
Event: LV 1 On
Date: dd.mm.yyyy
Time: hh:mm:ss
Event:
• LV 1 On = Limit value 1 On
• LV 1 Off = Limit value 1 Off
• LV 2 On = Limit value 2 On
• LV 2 Off = Limit value 2 Off
• Sensor fault.
Submenu 3
Limit values
Alarm relay
Limit values
Alarm relay
0/4 mA: on
10/12 mA: off
20 mA: off
0/4 mA: on
10/12 mA: off
20 mA: off
45