General Operation; Validated Processing Procedure - B.Braun Acculan 3Ti Manual De Instrucciones

Aesculap Power Systems
Acculan® 3Ti attachments

8.3 General operation

Risk of injury caused by
aerosol formation or particles
during reaming, cutting or
drilling!
WARNING
Always
protection when using the
drill and reamer motor
unit.
Risk of burns to skin and
tissue caused by hot, blunt
tools!
WARNING Do not use damaged or
defective tools.
Start the motor powering the attachment at
moderate speed.
To avoid slipping, apply only moderate pressure.
To avoid tool breakage, do not bend the tool.
Cool the tool during operation. This will improve
chip removal and reduce the risk of necrosis.
14
9.
Note
Adhere to national statutory regulations, international
standards and guidelines, and local, clinical hygiene
instructions for sterile processing.
wear eye
Note
For patients with Creutzfeldt-Jakob disease (CJD),
suspected CJD or possible variants of CJD, observe the
relevant
reprocessing of the products.
Note
Mechanical processing should be preferred over
manual cleaning, as mechanical processing produces
better and more reliable cleaning results.
Note
Up-to-date information on processing can be found on
the Aesculap Extranet at www.aesculap-extra.net
Note
Successful processing of this medical product can only
be ensured if processing is performed through a
validated processing procedure. The user/processor is
responsible for the validation.
Due to process tolerances, the manufacturer's
specifications can only serve as an approximate guide
for assessing the processing procedures applied by the
individual operator/processors.
Validated processing proce-
dure
national regulations concerning the