Conergy SmartControl System Manual De Uso página 22

Data updating
LED indicators
Conergy SmartControl System
The system monitoring portal provides you with the option of
deciding the interval at which the system's measured data is
transmitted. You can set the update interval to a value of your
choice between 15 minutes and 3 days. When shipped the
updating interval is set so that data are transmitted to the
system monitoring portal once a day.
Each time data are transmitted, the Conergy SmartControl
compares the setting with regard to the updating interval and
the warning threshold. If you have changed a setting in the
system monitoring portal, then it will be applied to the next
data transmission from the Conergy SmartControl.
Status
Measure
Transfer
Alarm
Fig. 3-6: LED indicators on the Conergy SmartControl
The LED indicators on the Conergy SmartControl can light up
either green or red. Red lights in one or more LEDs indicate a
fault (see Chapter 9, page 81).
Status
Flashing
Measure
Flashing
Transfer
Lit up
Flashing
rapidly
Alarm
1
Lit up
1 LED Alarm indicator goes off once the alarm is
transmitted.
Operating manual
3 Product description
Conergy SmartControl is
working
Conergy SmartControl is
receiving measured data
Conergy SmartControl is
transmitting measured
data
Transfer of a firmware
update to the Conergy
SmartControl
Conergy SmartControl
detects an alarm
21