Cable Types Between The Components - Conergy SmartControl System Manual De Uso

5 Important installation instructions
32
5.2

Cable types between the components

Connection between
ET sensor and Conergy
SmartControl
CAN converter and
Conergy SmartControl
CAN converter and 2nd
CAN converter
Central inverter of the
Conergy IPG seriesand
CAN converter
Conergy SmartControl
and power supply unit
Power supply unit and
electricity grid
Conergy SmartControl
and analogue tele-
phone connection
Conergy SmartControl
and Internet (via router)
Conergy SmartControl
and Conergy Control-
Center (direct connec-
tion)
Conergy IPG Smart-
Connect and Conergy
SmartControl
1
The maximum length of the cables depends on the type of
cables and inverters used, as well as other environmental
conditions. This means that Conergy cannot give precise
values. Standards and technical directives must be
observed (see Chapter 1.6, page 7)
2
Only when using a single Conergy SmartControl.
Operating manual
Cable type
4-pole cable;
e. g. LiY(C)Y
2
4 x 0.50 mm
Mounting rail bus
connector
Assembled cable
(included in
delivery)
2-pin, twisted,
screened cable
Mounting rail bus
connector
3-pole cable;
e. g. NYM
2
3 x 1.5 mm
Telephone cable
(analogue)
2
Ethernet network
cable
Crosslink Ether-
net network cable
CAN cable
Conergy SmartControl System
Max. length
50 m
–
0.1 m
1 km
–
Cannot be
1
specified
3 m
–
–
250 m