Conergy SmartControl System Manual De Uso página 50

Conergy SmartControl System
Connecting the 230 V power supply to the power supply
unit
1. Remove the terminal strip from the power supply unit.
2. Loosen the connecting screw on one lead.
3. Put a cable end sleeve on the end of the cable.
4. Insert the cable end into the screw terminal.
5. Tighten the terminal screw.
6. Check that the screw terminal is fastened securely.
7. Repeat this procedure for all.
8. Push the terminal strip onto the power supply.
Fig. 6-13: Terminal strip on the power supply unit
Operating manual
6 Assembly and installation
49