Conergy SmartControl System Manual De Uso página 59

6 Assembly and installation
6.8.2
58
5
1
9 6
Fig. 6-19: Terminator
Fitting the terminator
1. Fitting the terminating resistor between PIN 2 and 6 of the
RS485 interface.
Tightening torque of the slotted screw max. 0.05 Nm.
Connecting a second converter (optional)
CAN converters do not communicate via the CAN bus of the
DIN top-hat rail, and so they must be connected to one
another. The 10 cm long, preassembled cable is included in
the delivery.
Connecting CAN converters to one another
1. Fit the terminal strip of the assembled cable into the first
CAN converter (3).
2. Fit the other terminal strip of the assembled cable into the
second CAN converter (4).
(1) (2)
Fig. 6-20: Connecting two CAN converters to one another
(view from above)
Operating manual
(3)
Conergy SmartControl System
(4)