Conergy SmartControl System Manual De Uso página 79

8 Conergy ControlCenter
Requirements
78
Direct Ethernet connection with the Conergy
SmartControl
| Connection via a Crosslink Ethernet network cable
| The PV system network must be equipped with a DHCP
server or all subscribers will have an IP in the same address
range.
Connecting to the system
1. Download the Conergy ControlCenter software onto the
computer from the Conergy website.
2. Install Conergy ControlCenter on the computer. Please
note that administrator rights are necessary to do this.
3. Establish a network connection.
This operating manual does not contain detailed
instructions on how to establish a connection. Follow the
operating manual for the router. Note the requirements
stated above before attempting this.
4. Launch the software.
The Connection page comes up automatically.
5. Select the network your system is connected to.
6. Check the entries under Subnet IP and Subnet mask and
correct if necessary.
7. Press Connect.
Operating manual
Conergy SmartControl System