Corghi ET 1450 Manual De Uso página 100

- modify the displayed distance value by pressing the
read number is set
- on completion, press
of the new dimensions, or
WARNING
If the diameter and distance values between the two balancing planes, recalculated
on a statistical basis starting from the rated geometric data of the wheel, exceed the
normally accepted interval stated in the technical data section, the message "A 5" is
displayed.
ENTERING WHEEL DIMENSIONS IN
THE ALU1P AND ALU2P BALANCING
With this programme the real wheel data have to be set in relation to the real balancing
planes rather than the nominal values (as in standard ALU programmes). The balanc-
ing planes where the adhesive weights are to be applied may be selected by the user
according to the specific shape of the rim. It should be remembered, however, that in
order to reduce the quantity of the weight that is to be applied it is preferable to select
balancing planes that are as far apart as possible: if the distance between the two planes
is less than 37 mm (1.5"), the "A 5" message is displayed.
The various methods for inserting dimensions are described below based on the sup-
plied devices:
100
to display the unbalance values recalculated on the basis
to perform a wheel spin.
PROGRAMMES
15
keys until the
Operator's Manual ET 1450