CAUTION
Take the utmost care when unpacking, assembling, lifting and setting up the machine
as indicated below.
Failure to observe these instructions can damage the machine and compromise the
operator's safety.
Remove the original packaging materials after positioning them as indicated on the
packaging and keep them intact so the machine can be safely shipped at a later date
if necessary.
CAUTION
Choose the place of installation in compliance with local regulations on occupational
safety.
In particular, the machine must only be installed and used in protected environments
where there is no risk of anything dripping onto it.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in the
place of use should be at least 300 lux.
The floor must be strong enough to support a load equal to the weight of the equipment
plus the maximum load allowed. The support base on the floor and the envisaged fixing
means must also be taken into account.
Environmental operating conditions must comply with the following requirements:
- relative humidity ranging from 30% to 80% (without condensation);
- temperature ranging from +5° to +40°C.
WARNING
For information concerning the technical features, warnings and maintenance in-
structions consult the related operator manuals provided with the documentation of
the machine.
CAUTION
The machine must not be operated in potentially explosive atmospheres.
The machine is supplied partially disassembled and is to be assembled according to
the procedures described below.
76
INSTALLATION
Operator's Manual ET 1450