Corghi ET 1450 Manual De Uso página 113

This programme is used to display the total number of spins performed by the machine since its
first start-up (tot SPi), the number of spins performed since the last unbalance calibration (CAL
SPi) and the number of partial spins performed since the machine was last started (PAr SPi).
The programme differs depending on whether it is used in the CAR or TRUCK working envi-
ronment.
Proceed as follows to recall this programme:
• press the key
• use the
• Press the key to display the total number of spins performed by the machine since
its first start-up (tot SPi)
• Press the key to display the number of spins performed since the last sensitivity
calibration (CAL SPi). It is reset at each new calibration.
• Press the key to display the number of spins performed since the last sensitivity
calibration (PAr SPi). It is reset each time it is turned off.
• press the key to exit.
GENERAL CONFIGURATIONS - SET UP
The machine can be configured according to your requirements. The following configurations
are available:
- Unbalance unit of measurement
- Unbalance rounding-off
- Warning OPT
- Rim diameter display unit of measurement
- Rim width display unit of measurement
- Beeper
- Setting - Application position for adhesive weights
- Display brightness setting
- Setting - Display of diameter and AWC program for truck wheels
- Setting - ALUP balancing program for truck wheels
- Setting TES Energy Saver Mode Time
- LED light
- Laser indicator
Operator's Manual ET 1450
WHEEL SPIN COUNTER
keys to search for -SP in-
UK
113