Corghi ET 1450 Manual De Uso página 123

The machine allows the operator to disable or modify the lighting mode.
Proceed as follows to make these settings:
- Press the key.
- use the
- press the key to confirm
- use the
- press the key to change the setting:
or LEd oFF to disable the lighting device
or LEd 1 to activate the lighting device when acquiring dimensions during an
ALU1 P or ALU2 P balancing programme, at the end of a spin cycle in
the case of residual unbalances for 30 seconds, in CP (centred position)
for an additional 30 seconds
or LEd 2 in this configuration, the light will turn on, in addition to the situations
indicated above (in the Led1 mode) also during the entire measurement
cycle, when acquiring dimensions in all balancing programmes and in
the Hidden Weight programme when selecting the two planes behind
the spokes.
- press the key to confirm and exit.
SET UP - LASER INDICATOR
The machine allows the operator to enable or disable the laser device.
Proceed as follows to make this setting:
- Press the key.
- use the
- press the key to confirm
Operator's Manual ET 1450
SET UP - LED LIGHT
keys to search for SEt UP
keys to search for LEd 1 (LEd 2 or LEd oFF if previously set)
keys to search for SEt UP
UK
123