Corghi ET 1450 Manual De Uso página 131

CAUTION
The "Spare parts" handbook does not authorise the user to carry out work on the machine
with the exception of those operations explicitly described in the User Manual. It only
enables the user to provide the technical assistance service with precise information, to
minimise delays.
CAUTION
The company is not to be held responsible for any claims deriving from the use of non-orig-
inal spare parts or accessories.
CAUTION
Unplug the machine from the socket and make sure that all moving parts have been locked
before making any adjustments or maintenance work.
Do not remove or modify any part of the machine (except for service interventions).
WARNING
Keep the working area clean.
Never use compressed air and/or jets of water to remove dirt or residues from the machine.
Take all possible measures to prevent dust from building up or raising during cleaning
operations.
Keep the wheel balancer shaft, the securing ring nut, the centring cones and flange clean.
These components can be cleaned using a brush previously dripped in environmentally
friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent damage
that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from dust and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
INFORMATION REGARDING MACHINE
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts
and dispose of them separately in accordance with current provisions as prescribed by law.
Operator's Manual ET 1450
MAINTENANCE
DEMOLITION
UK
131