Corghi ET 1450 Manual De Uso página 128

- Notice PREMATURE EXIT from the unbalance optimisation program
Abo rt
- Press the
- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase of
--I- -I--
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete the programme
without inversion.
- This message indicates that the operator is in the "positioning the weights
HId dEn
no no
- This message is displayed if the wheel is balanced on the outer side
- This message indicates that the machine is set for acquiring the P1 position
in -1-
- This message indicates that the machine is set for acquiring the P2 position
in -2-
- This message is displayed for approx. 3 seconds if the selected angle is
no -2-
- This message indicates the reference for acquiring the two points P1
in H.X
CAL GO
- Calibration spin
- End of calibration spin On the manual spin version of the machine, apply
CAL StP
CAL SP1
- Message prompting operator to execute fourth calibration spin
CAL SP2
- Message prompting operator to execute fifth calibration spin
End CAL
- This message indicates the end of the unbalance calibration programme
GO ALU
- Spin with ALU programme selected
- Spin with Static programme selected (car/motorcycle environment) or
St
- Imbalance values exceeding 999 grammes for passenger car wheels, or
ccc ccc
128
key to confirm or the
programme
the programme.
behind the spokes Hidden Weight" programme
behind the first spoke
behind the second spoke
greater than 120 degrees, indicating that the procedure must be repeated
correctly
and P2 behind the spokes. Depending on the configuration made by
the operator, the message shown on the right-hand display may be H3,
H6 or H12. If the laser indicator is enabled, the reference is the 6 o'clock
position (H.6)
the pneumatic brake
when the Static balancing programme is selected in the vehicle working
environment
exceeding 1990 grammes for truck wheels.
key to remain in the
Operator's Manual ET 1450