Corghi ET 1450 Manual De Uso página 104

- You can stop the spin during the data measurement stage pushing the appropriate lever
(D, fig. 4). In this case the message "A Stp" will appear on the display.
- Secure the wheel using the special device.
- Press and hold the two buttons D and I on the casing simultaneously to spin the wheel
(Fig. 4);
- Once the cycle is complete, the imbalance values are displayed and the machine
automatically stops wheel rotation.
- Release the two buttons;
- Place the wheel in the position indicated by the machine; the brake is applied auto-
matically.
- Apply the balance weights indicated by the machine.
WARNING
To obtain results of maximum precision, do not subject the machine to improper stress
during processing of the unbalance signals.
- If the machine acquires incorrect signals during the spin cycle the message "E 32" will
be displayed indicating that the spin cycle must be repeated.
- If unbalance is greater than 1000 grams, the display will show only the part in excess of
the first kilogram with three decimal points. For example: 1250 g is shown .2.5.0
- If calculated unbalance values are greater than the maximum permitted (999 in CAR
mode and 1990 in TRUCK mode) the message "CCC" will be shown on the display.
- The spin may be stopped during acquisition by releasing one or both of the spin launch
buttons. In this case, the message "A StP" appears briefly on the display.
WARNING
Before carrying out the "WHEEL SPIN" procedure, the operator must make sure that
there are no exposed persons, in area A in fig. 17, at risk of:
- blows from any foreign bodies on the tyre, flung out during wheel spin;
- tangling and contact with the wheel clamping device and the wheel itself.
104
WHEEL SPIN
- FOR MOTORIZED VERSION -
Special conditions
Operator's Manual ET 1450